ASTM A Scope – This specification covers bolts, threaded rod, and anchors in diameters ranging from 1/4″ through 3″ (inclusive). It is a medium strength bolt . ASTM A is a material regulation covering hex headed bolts, rods, and anchor bolts. They are typically general use fasteners used in standard engineering. ASTM A is virtually identical in chemistry and strength to ASTM A and SAE J grade 5, but covers a larger diameter range and is not restricted by.
|Published (Last):||15 October 2005|
|PDF File Size:||10.5 Mb|
|ePub File Size:||5.59 Mb|
|Price:||Free* [*Free Regsitration Required]|
The one listed here is the one we receive the most requests for.
You can edit the text in this area, and change where the contact form on the right submits to, by entering edit mode using the modes on the bottom right.
Type 3 fasteners shall be weathering steel and shall conform to one of the chemical compositions specified.
ASTM A – Portland Bolt
It is informational only and not an official part a494 the standard; the full text of the standard itself must be referred to for its use and application. Historical Version s – view previous versions of standard. Contact Us Use the form on the right to contact us. This abstract is a brief summary of the referenced standard. Steel, as defined by the American Iron and Steel Institute, shall be considered to be alloy when the max range given for the content of alloying elements exceeds one of more of the following limits:.
ASTM A449 Specification
No other units of measurement are included in this standard. This specification2 covers quenched and tempered steel hex cap screws, bolts, and studs having a minimum tensile strength.
ASTM does not give any warranty aetm or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
Plain carbon steel, carbon boron steel, alloy steel, or alloy boron steel. Nuts of other grades and styles having specified proof of load stresses per ASTM A specification greater than the specified grade and style of nut are suitable. Plain carbon steel, carbon boron steel, alloy steel or alloy boron steel. They are a494 by type denoting chemical composition as follows: They are designated by type denoting chemical composition as follows:.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
CNC maching, welding, threading.
ASTM A Specification – Boltport Fasteners LLP
Tensile strength, proof load, hardness tests, and axial tension tests shall be performed to conform with the specified requirements. There are other types of A We provide both stocked and custom anchor bolts, anchor bolt assemblies, threaded rod, bolts, bent bolts, nuts, washers, turnbuckles, clevises and more.
Link to Active Atsm link will always route to the current Active version of the standard.
The fasteners are intended for general engineering use. Steel, as defined by the American Iron and Steel Institute, shall be considered to be alloy when the max range given for the content of alloying elements exceeds one of more of the following limits: Type 1 fasteners shall be plain carbon steel, carbon boron steel, alloy steel, or alloy boron steels conforming to the requirements.
The term “fasteners” in this specification denotes hex cap screws, bolts, and studs.
Or in which a definite range or minimum quantity of any of the following elements is specified or required within the limits of the recognized field of constructional alloy steels. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.