13 PDF Article

T5 = Application of wax. T6 = Application of soap. Supersedes;. BS EN BS AMS Phosphate treatment is defined by reference to a particular. Find the most up-to-date version of BS EN at Engineering BS EN October Phosphate conversion coatings of metals. Method of specifying requirements. Historical Version.

Author: Maugar Fenritilar
Country: Chile
Language: English (Spanish)
Genre: Marketing
Published (Last): 28 October 2008
Pages: 27
PDF File Size: 14.3 Mb
ePub File Size: 6.33 Mb
ISBN: 346-6-41895-352-2
Downloads: 1779
Price: Free* [*Free Regsitration Required]
Uploader: Vudomi

If necessary, scrub the coating off with a rubber wiper. Filter this off after 10 minutes of heating and rinse thoroughly with hot distilled water. Add 10 ml of the ammonium molybdate solution and 5 g of ammonium nitrate 124476 the acidified filtrate, and leave the mixture to stand for at least 15 minutes.

Decoloration of the permanganate solution identifies the precipitate as calcium oxalate, thus indicating the presence of calcium in the coating. The committee decided to retain the specifications of subclause 7.

Using half of the solution, test for manganese by adding 0,5 g of bismuth sodium trioxide, thus oxidizing any manganese present to permanganate; a reddish violet colour indicates the presence of manganese. EN comprises 12 pages.

  AL RAHEEQ AL MAKHTUM URDU PDF

磷化处理EN 标准(英文版)_百度文库

A yellow precipitate indicates the presence of phosphate. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Management Centre or to any CEN member. To establish that a wn is a manganese phosphate coating, it is sufficient to establish the presence of manganese for ferrous substrates only cf. A white precipitate, which may have a slight green tinge due to the presence of a small amount of iron, indicates the hs of zinc.

A comma is used as the decimal marker.

BS EN 12476:2000

A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the gs versions. The detection of phosphate in a coating shall be taken as proof that it is a phosphate coating cf.

Use the other half of the solution to test for the presence of calcium as described in subclause NA. To identify the purified white precipitate as calcium oxalate, remove it from the filter by spraying with hot distilled water, and then add about 50 ml of distilled water.

  CATALOGO DOLOMITE SANITARI PDF

To establish that a coating is a zinc phosphate or a zinc calcium phosphate coating, it is sufficient to establish the presence of zinc or zinc and calcium, respectively for zinc-free substrates cf. To decompose the excess hydrogen peroxide, boil the resulting solution for a few minutes and then cool it to ambient temperature.

Previous editions DIN If neither manganese nor zinc has been detected in a phosphate coating on a substrate of ferrous material, then the coating is certain to be an iron phosphate coating. If necessary, adjust the pH to the desired level by adding solid ammonium chloride.